User's Manual

IPL T CR48 Reset Mode Summary
Mode Activation Result Purpose and Notes
Use Factory Firmware
1
Hold down the recessed Reset button
while applying power to the IPL T CR48.
NOTE: After a mode 1 reset is
performed, update the firmware
of the unit to the latest version.
Do not operate the IPL T CR48
firmware version that results
from the mode 1 reset. This
mode temporarily resets the unit
to factory default until power is
recycled. If you want to use the
factory default firmware, you
must upload that version again.
The IPL T CR48 reverts to the
factory default firmware.
Event scripting does not start if the
unit is powered on in this mode. All
user files and settings (such as drivers,
adjustments, and IP settings) are
maintained.
NOTE: If you do not want to update
firmware, or you performed a
mode 1 reset by mistake, cycle
power to the unit to return to the
firmware version that was running
prior to the mode 1 reset. Use the
0Q SIS
™
command to confirm that
the factory default firmware is no
longer running (look for asterisks
following the version number).
Use mode 1 to revert to the factory
default version if incompatibility issues
arise with user-loaded firmware.
NOTE: User-defined Web pages may
not work correctly if using an
earlier firmware version.
Run/Stop Events
3
Hold down the Reset button for about
3 seconds until the Power LED blinks
once, then release and press Reset
momentarily (<1 second) within
1 second*.
Mode 3 turns events on or off.
If the events are currently stopped
following the momentary press, the
power LED flashes twice, indicating
the starting of events. If the events
are currently running following the
momentary press, the Power LED flashes
three times indicating the stopping of
events.
Mode 3 is useful for troubleshooting.
Reset All IP Settings
4
Hold down the Reset button for about
6 seconds until the Power LED blinks
twice (once at 3 seconds, again at
6 seconds). Then, release and press
Reset momentarily (for <1 second)
within 1 second*.
Mode 4:
 Enables ARP capability
 Sets the IP address back to factory
default (192.168.254.254)
 Sets the subnet back to factory
default
 Sets the default gateway address to
the factory default
 Sets port mapping back to factory
default
 Turns DHCP off
 Turns events off
Mode 4 enables you to set IP address
information using ARP and the MAC
address.
Reset to Factory Defaults
5
Hold down the Reset button for about
9 seconds until the Power LED blinks
three times (once at 3 seconds, again at
6 seconds, again at 9 seconds). Then,
release and press Reset momentarily (for
<1 second) within 1 second*.
Mode 5 performs a complete
reset to factory defaults
(except the firmware).
 Does everything mode 4 does
 Clears driver-port associations and
port configurations
 Removes button/touchpanel
configurations
 Resets all IP options
 Removes scheduling settings
 Removes/clears all files from the
IPL T CR48
Mode 5 is useful if you want to start
over with configuration and uploading,
and also to replace events.
*For modes 3, 4, and 5, nothing happens if the momentary press does not occur within 1 second.
IPL T CR48 • Installation and Operation 9