User's Manual

Sending an e-mail alert through Telnet
To complete the process of sending an e-mail alert, you must send it through a Telnet session
and receive confirmation. To do so:
1. Open a Telnet session. See Accessing and using Telnet, later in this section, for
instructions on how to do this.
2. Use the “Send e-mail” SIS command to send the alert to the e-mail address of a numeric
mailbox (figure 18). See Programmer’s Guide for the Telnet and Web Browser,
earlier in this section, for specific command code.
For example, the code for sending an alert from the 4th numeric mailbox would be:
Esc 4 SM}
Refer to the Global Configurator Help file for detailed information on monitoring and
scheduling.
Upgrading the firmware
Firmware upgrades become available as improvements are made to the versatility and
functionality of the IPL T CR48. These upgrades are available for download from the Extron
Web site (www.extron.com).
CAUTION: The firmware file you select to upload must have an *.S19 extension.
Uploading the incorrect file may cause your unit to stop working.
To upgrade the firmware:
1. Click Firmware Upgrade on the menu (on the left side of the window). The
Firmware Upgrade screen (figure 19) is displayed.
Figure 19. Firmware Upgrade Screen
2. Click Browse to find the most current available version of the firmware that has been
downloaded on your PC.
3. If you find a later version than the one shown above the box, click Upload to upgrade
to the newer version.
CAUTION: If you leave the page before upload is complete, the upload will be
cancelled.
IPL T CR48 • Communication and Control 21