- Extron Electronics Remote Control Panel User's Manual MKP 2000

MKP 2000 Remote Control Panel • SIS Operation
MKP 2000 Remote Control Panel • SIS Operation
SIS Operation, cont’d
Command/response table for MKP SIS commands (continued) Command ASCII Command Response Additional description
(host to MKP) (MKP to host)
4-8
Command/response table for MKP SIS commands Command ASCII Command Response Additional description
(host to MKP) (MKP to host)
Front panel security lockout (executive mode)
Lock front panel 1x Exe1 Lock front panel.
Unlock front panel 0x Exe0
Unlock front panel.
Read front panel lock x
X1
Read front panel lock: 1 = locked, 0 = unlocked.
Pass-through (RS-232 port redirect)
Configure redirect mode
Esc
X2
*
X3
*
X4
*
X5
CD Cpn
X2
•Ccd
X3
,
X4
,
X5
Turn redirect mode on.
Example:
Esc
1*2*50*10D*CD Cpn01•Ccd00002,00050,00000L
Disable redirect
Esc
X2
*0CD Cpn
X2
Ccd00000,00000,00000L
View redirect
Esc
X2
CD
X3
,
X4
,
X5
View redirect mode on/off status.
View, information, part number, and firmware requests
Information request I MKP•2000 Report model name.
Request for part number N 60-682-00
See Appendix A for part numbers.
Query firmware version Q
X6
Firmware version x.xx.
Query verbose firmware version 0Q
X7
Provide a detailed status of the Ethernet protocol firmware, the MKP controller firmware, and any firmware upgrade. The firmware that is running is marked by asterisk (*). A caret (^) indicates that the firmware has a bad checksum or an invalid load. ?.?? indicates that firmware is not loaded.
Response description: Ethernet protocol firmware version - controller firmware version - updated firmware version
Query status S
X8
Voltage and temperature readings.
4-9
Resets
Absolute reset
Esc
ZQQQ Zpq Performs all of the reset functions as the master
reset, sets the MKP’s IP address to 192.168.254.254, and sets the subnet mask to 255.255.0.0.
Verbose mode
Set verbose mode on
Esc
X9
CV Vrb1 The MKP reports all status changes to the device
that sent the command.
Read verbose mode
Esc
CV
X1
Read connection’s security level
Esc
CK
X10
Password level protection assigned.
IP setup
Set MKP name
Esc X11
CN Ipn
X11
Assign a name to the MKP.
Set MKP name to factory default
Esc
•CN Ipn•
X12
Reset the MKP’s name to the factory default.
Read MKP name
Esc
CN
X11
Read assigned MKP name (
X11
may be
X12
).
Set time/date
Esc X13
CT Ipt
X14
Set the time and date.
Read time/date
Esc
CT
X14
Read the time and date.
Set GMT offset
Esc
X15
CZ Ipz
X15
The divider between hours and minutes is a period.
Read GMT offset
Esc
CZ
X15