User’s Manual MTP R 15HD RSA D MTP 15HD Decora Receiver Extron USA - West Headquarters +800.633.9876 Inside USA / Canada Only +1.714.491.1500 +1.714.491.1517 FAX Extron USA - East Extron EMEA Extron Asia Extron Japan Extron China Extron Middle East +800.633.9876 +800.3987.6673 +800.7339.8766 Inside Europe Only Inside Asia Only +81.3.3511.7655 +81.3.3511.7656 FAX +400.883.1568 Inside USA / Canada Only +971.4.2991800 +971.4.2991880 FAX +1.919.863.1794 +1.919.863.1797 FAX +31.33.453.
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
安全须知 • 中文 警告 这个符号提示用户该设备用户手册中 有重要的操作和维护说明。 电源 • 该 设 备 只 能 使 用 产 品 上 标 明 的 电 源 。 设 备 必须使用有地线的供电系统供电。 第三条线 （地线）是安全设施，不能不用或跳过。 这个符号警告用户该设备机壳内有暴 拔掉电源 • 为安全地从设备拔掉电源，请拔掉所有设备后 或桌面电源的电源线，或任何接到市电系统的电源线。 露的危险电压，有触电危险。 电源线保护 • 妥善布线， 避免被踩踏，或重物挤压。 注意 阅读说明书 • 用 户 使 用 该 设 备 前 必 须 阅 读 并 理 解所有安全和使用说明。 保存说明书 • 用户应保存安全说明书以备将来使 用。 遵守警告 • 用户应遵守产品和用户指南上的所有安 全和操作说明。 维护 • 所有维修必须由认证的维修人员进行。 设备内部没 有用户可以更换的零件。为避免出现触电危险不要自己 试图打开设备盖子维修该设备。 通风孔 • 有些设备机壳上有通风槽或孔，它们是用来防止 机内敏感元件过热。 不要用任何东西挡住通风孔。 锂电池 • 不正确的更换电池会有爆炸的危险。 必须使用与 厂家推荐的相同
Table of Contents Chapter One • Introduction ..................................................... 1-1 About the MTP 15HD Decora® Receiver . ............................ 1-2 RS-232 function ....................................................................... 1-3 Twisted Pair (TP) Cable Advantages . ................................... 1-3 Transmission distance ............................................................. 1-3 Chapter Two • Installation and Operation . ..................
Table of Contents, cont’d MTP R 15HD RSA D 1 Chapter One Introduction About the MTP 15HD Decora® Receiver Twisted Pair (TP) Cable Advantages 68-1463-01 Rev. A 09 08 All trademarks mentioned in this manual are the properties of their respective owners.
Introduction About the MTP 15HD Decora® Receiver The Extron MTP R 15HD RSA D is a mini twisted pair (MTP) receiver, in a Decora form factor, that auto-detects between audio or RS-232 serial data on the audio/RS-232 wire pair. The receiver is compatible with the entire line of Extron MTP 15HD transmitters and associated MTP products. RS-232 function When the audio/RS-232 portion of the TP link is RS-232, it is either unidirectional or bidirectional, selectable by a DIP switch.
Introduction, cont’d N The MTP units are designed for and perform best with Extron Enhanced Skew-Free A/V cable terminated in accordance with the TIA/EIA T 568 A wiring standard. CAT 5, 5e, and 6 cables are acceptable, but less preferable. We also recommend the use of preterminated and tested cables. Cables terminated on site should be tested before use to ensure that they comply with Category 5 specifications.
Installation Installation 2.50 (63.5 mm) The MTP R 15HD RSA D receiver can be installed in a one-gang electrical wall box with a Decora wall plate cover (supplied). The installation must conform to national and local electrical codes and to the wall plate’s size requirements. UL/safety requirements TP Pigtail The following Underwriters Laboratories (UL) requirements pertain to the installation of the Decora receiver into a wall or furniture. 1.
Installation and Operation, cont’d 5. Secure the wall box with nails or screws, leaving the front edge flush with the outer wall or furniture surface. See figure 2-2. Wall Stud Signal Output Cable Cable Clamp Screws or Nails Wall Stud Signal Output Cable Cable Clamp 10. Connect a video and an RS-232 and/or audio device to the front panel (see "Front panel features", later in this chapter, for connector details). 11. Restore the power supply, and test the transmitter/receiver system.
Installation and Operation, cont’d Connections and Settings See figure 2-4 to identify the rear and front panel connections on the receiver. MTP 15HD RSA D Rx Rear Panel N Most devices use negative sync. N Set the Composite Sync, SOG, and Video DIP switches as shown in the table below for the various input and output video formats. MTP 15HD RSA D Rx Front Panel Composite Sync switch (3) — Set this switch on (right) for RGBS or off (left) to output RGBHV or RGsB video. See the table below.
Installation and Operation, cont’d d e Output video connector — Connect a projector or other high resolution video device to this 15-pin HD connector. Audio RS-232 output connector — Insert a 3.5 mm, 5-pole captive screw connector into this jack for a mono audio and/or an RS-232 serial output. See "Audio/RS-232 cable termination", on page 2-12, to wire the connector for either or both formats.
RS-232- 2-10 MTP R 15HD RSA D • Installation and Operation MTP R 15HD RSA D • Installation and Operation Figure 2-6 — TP cable termination NOTE If you are using Enhanced Skew-Free™ A/V cable, use the TIA/EIA T568A standard only. Brown 8 Brown Blue-/H. sync– B-Y– Reserved Reserved Mono audioReserved Reserved B-Y+ Blue+/H.
MTP R 15HD RSA D • Installation and Operation Side Pins: RJ-45 Connector 12345678 Pin Insert Twisted Pair Wires T568A T568B Wire color Wire color Video input (via transmitter) RGB Component S-video Audio/RS-232 input Composite Stereo audio 1 White-green White-orange Red+/V. sync+ R-Y+ Chroma (C)+ Reserved 2 Green Orange Red–/V.
Installation and Operation, cont’d Audio/RS-232 cable termination Tx Rx RS-232 Device Do not tin the wires! Tip Ring Sleeve Mono Audio Output Ground ( ) Transmit (Tx) Receive (Rx) RS-232 Output The length of the exposed (stripped) portion of the copper wires is important. The ideal length is 3/16” (5 mm). Longer bare wires can short together. Shorter bare wires are not as secure in the direct insertion connectors and could be pulled out.
Installation and Operation, cont’d MTP R 15HD RSA D A Appendix A Installation and Operation Specifications Part Numbers Decora Template Dimensions 2-14 MTP R 15HD RSA D • Installation and Operation
Reference Information Specifications S/N �������������������������������������������������� >70 dB at maximum output (unweighted) CMRR ���������������������������������������������� >43 dB @ 20 Hz to 20 kHz Video Gain ������������������������������������������������� Unity Number/signal type ��������������������� 1 set of proprietary analog signals Connectors ������������������������������������� 1 female RJ-45 on a pigtail Video input — See MTP Series Transmitters' video output specifications.
Reference Information, cont’d Temperature/humidity ���������������� Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing Cooling ������������������������������������������� Convection, no vents Furniture mount ���������������������������� Yes, using a standard electrical wall box or Decora® size mud ring Enclosure type ������������������������������� Metal Enclosure dimensions Faceplate ����������������������������� 2.
Reference Information, cont’d Decora Template Dimensions Cables N Enhanced Skew-Free™ A/V UTP cables are not recommended for Ethernet/LAN applications. Enhanced Skew-Free™ A/V cable Part number Enhanced Skew-Free A/V cable (cut, various lengths) 26-569-xx Enhanced Skew-Free A/V 1000' (Bulk) (non-plenum) 22-141-03 Plenum enhanced Skew-Free A/V 1000‚ (Bulk) 22-142-03 If you need to create a template, use the dimensions shown on figure A-1, below. N The drawing is not full size or to scale.
Reference Information, cont’d A-8 MTP R 15HD RSA D • Reference Information
