- Extron Electronics Mountable Interfaces User's Manual

RGB 400 Series Templates

Templates, cont’d

B-3

RGB 402 and RGB 404 Cut-out Template

Use this template for cutting a hole in a wall or furniture for

the 3-gang size electrical box for an RGB 402 or RGB 404.

The light gray area represents the layout of the

electrical box (3.75"H x 5.60"W) against the rear

of the RGB 402 or RGB 404 front panel.

The dashed line indicates the cut-out area

(3.95"H x 5.80"W) for installing

the electrical wall box.

To install the interface

without

a wall box,

use the cut-out area (3.00"H)

indicated by the dotted line.

B-2

All the templates in this section are actual size. Also, they

all include the recommended 0.1” (0.25 cm) clearance on all

sides of the electrical wall box to allow room for the raised

areas surrounding the knockouts.

The dashed line in each template indicates the cut-out area

for installing a wall box. If you plan to install the interface

without a wall box, use the smaller cut-out area indicated

by the dotted lines.

RGB 400 and RGB 406 Cut-out Template

Use this template as a guide for cutting a hole in a wall or

furniture for the 2-gang size electrical box in order to install

an RGB 400 or RGB 406.

The light gray area represents the layout of the

electrical box (3.75"H x 3.75"W) against the rear

of the RGB 400 or RGB 406 front panel.

The dashed line indicates the cut-out