- Extron Electronics Universal Interfaces User's Manual

RGB 130
xixi
xixi
xi , 134
xixi
xixi
xi , 150
xi xi
xi xi
xi Controls and Installation
Controls and Installation, cont’d
2-11
Figure 2-13 — RGB 150
xixi
xixi
xi installation
2. Connect the interface cable marked “Video input” to
the computer’s video output (where the monitor was
originally connected).
3. For audio connections, refer to the following
“Connecting Audio” section for important
information concerning unbalanced and balanced
audio. Connect audio input to the interface’s front
panel audio input jack. Connect audio output to the
captive screw connector on the interface’s rear panel.
4. Use BNC cables to attach the interface to a projector
or other display device.
RGsB – If coax cables are connected and
terminated (75 ohms) to the red, green, and
blue channels only, and the SOG OUT switch
is set to on (see page 2-14), the output will be
sync on green.
RGBS – If the S (composite sync) cable is
connected, the output will be composite sync.
RGBHV – If both the H & V cables are
connected, the sync output is separate
horizontal and vertical.
PC Computer
Monitor Projector
Audio
Power
or
OUTPUT
SOG OUT
DDSP
SERR
SPARE
Rear
50/60 Hz
100-240V 0.5A
LEVEL/
PEAK
0.8V 50%
UNITY
0.9V 100%
INPUT
RGB 150 xi
UNIVERSAL INTERFACE W
/ADSP
Front
H. SHIFT
MIN/MAX
ID PIN 4
ID PIN 11
AUDIO
RGsB
R
H
G
V
B
S
RGBS
R
H
G
V
B
S
RGBHV
R
H
G
V
B
S