User’s Manual BNC Mini-High Res, 75 Ohm Termination Kit Connector Installation Guide (60-073-01)
BNC Termination Kit Instructions ______ This document is a compilation of Extron’s instructions, together with copies of AMP® Instruction booklets that are provided with each of the AMP tools included in this kit.
BNC Connector Installation Introduction Use these instructions to install BNC connectors on Extron’s 75 ohm Super HighResolution coax cable. The kit includes the following required tools: • AMP® Coaxial Cable Stripper • AMP® Pro-Crimper (with dies to crimp both center contacts and the ferrules) • Wire Cutters/Strippers Before using each of the AMP tools, go to the appropriate section of this document for instructions.
BNC Connector Installation Extron • 75 Ohm BNC Termination Kit • User’s Guide 2
BNC Connector Installation Mini coax 3 Extron • 75 Ohm BNC Termination Kit • User’s Guide
BNC Connector Installation If setup is required, use RG174 side of the red gauge block.
BNC Connector Installation 5 Extron • 75 Ohm BNC Termination Kit • User’s Guide
BNC Connector Installation Extron • 75 Ohm BNC Termination Kit • User’s Guide 6
BNC Connector Installation 7 Extron • 75 Ohm BNC Termination Kit • User’s Guide
BNC Connector Installation Warning: The die retaining pins must be in place or the connector may skew and jam.
BNC Connector Installation 9 Extron • 75 Ohm BNC Termination Kit • User’s Guide
BNC Connector Installation Extron • 75 Ohm BNC Termination Kit • User’s Guide 10
BNC Connector Installation 11 Extron • 75 Ohm BNC Termination Kit • User’s Guide
