User guide

DTP DVI 330 Tx/Rx Transmitter and Receiver • Reference Information 12
3. Locate, lift off, and discard jumpers JMP2 and JMP3 from both units (see figure 10).
Transmitte
rR
eceiver
J
MP3
JMP2
JMP2
JMP3
Figure 10. Jumper Locations
4. Reinstall the covers on both units, securing them in place with the screws removed in
step 2.
5. Reinstall both units in their racks or other installation option (see Mounting the
Transmitter and Receiver on page 10).
6. If you are using shielded cable, disconnect the cable shield from the connector at
either end of the cable.
7. Obtain a second 12 V power supply (one supply is provided with the transmitter and
normally powers both units), and locally power both units (see Power supply wiring
on page 8).