User`s manual

DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-4
DVI 201 and HDMI 201 Tx/Rx • Installation and Operation
2-5
Under-furniture mounting
The transmitter or receiver can be mounted under a table or
other horizontal surface using an optional Extron MBU 125
under-desk mounting kit (part #70-077-01). Mount the
transmitter or receiver under a desk or table as follows:
1. Secure the under-desk mounting brackets to the
transmitter or receiver with the four machine screws
provided in the mounting kit (fi gure 2-3).
Figure 2-3 — Under-desk mounting
2. Hold the transmitter or receiver with attached brackets
against the underside of the desk or other furniture. Mark
the location of holes for screws on the desk.
3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside or inside (the concealed side) of the
furniture, where the transmitter or receiver will be located.
4. Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw head protrudes.
5. Align the installed screws with the slots in the mounting
brackets, and place the transmitter or receiver against the
surface, with the screws through the bracket slots.
6. Slide the transmitter or receiver slightly forward or back,
then tighten all four screws to fasten it in place.
Through-furniture mounting
The transmitter or receiver can be mounted through a desk or
other furniture using an optional Extron MBD 129 through-desk
mounting kit, part #70-077-02. Mount the transmitter or receiver
through a desk or table as follows (fi gure 2-4):
Figure 2-4 — Through-desk mounting
1. Loosely attach the mounting brackets to the transmitter
or receiver using the four machine screws and washers
supplied with the mounting kit.
2. Hold the transmitter or receiver against the inside of the
surface through which it will be mounted. Mark the four
screw holes on the inside of the surface to which you are
mounting the device.
3. Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
where you made marks.
4. Using the four wood screws provided, secure the brackets
to the mounting surface.