Owner's manual

Flexible Conduit Kit • Installation Instructions
2
Flexible Conduit Kit Installation Instructions, cont’d
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
800.633.9876 714.491.1500
FAX [phone]
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort, The Netherlands
+800.3987.6673 +31.33.453.4040
FAX [phone]
Extron Electronics, Japan
Kyodo Building, 16 Ichibancho
Chiyoda-ku, Tokyo 102-0082
Japan
+81.3.3511.7655 FAX [phone]
.
Extron Electronics, Asia
135 Joo Seng Rd. #04-01
PM Industrial Bldg., Singapore 368363
+800.7339.8766 +65.6383.4400
FAX [phone]
www.extron.com
5. Strip away 1½" of the outer jacket (US/Domestic HSA) and ½" of the individual wires’ insulation.
Installing the Replacement Cable
1. Twist together the two supply (blue) wires (one from the HSA and one from the Flexible Conduit Kit), the two
return (brown) wires, and the two ground (green/yellow) wires in the HSA. Twist one of the provided wire
nuts onto each twisted pair.
2. Carefully tuck the three wire nuts and the spliced wires
into the HSA through the power input connector plate hole.
3. Use the provided tie wrap to bundle the spliced power
cables and strap them to the bottom of the enclosure
(see the fi gure at right).
N
Tie-wrapping the spliced bundles to the bottom of the HSA
is important to the HSA’s freedom of movement. For the
smaller HSA 200 models, keeping the bundles fl at and fl ush
with the bottom of the enclosure is critical.
In the fi gure at right, the wire nuts are lifted to show the tie-
down location; for smooth HSA operation, the wire bundles
and nuts must be pressed down into the bottom of the HSA.
4. HSA 200/HSA 222/HSA 822 — Reinstall the access panel
(HSA 200/HSA 222) or shroud (HSA 822) removed in
“Removing the Old Cable”, step 2, on the previous page.
5. Use the screws provided with the Flexible Conduit
Kit to secure the conduit plate to the HSA (see the
photo at right).
N
If the HSA was installed in a table, reinstall the HSA.
See the HSA User’s manual.
W
Ensure power is removed from the UL-listed AC
distribution box before connecting the power
cable. Lethal voltages are present in the AC
distribution box.
6. Remove power from the AC distribution box.
N
Ensure the AC distribution box is rated for and
equipped with a 20-amp circuit breaker.
7. Wire the free end of the AC power cable into the AC
distribution box.
Cable Bundle Tied
to Bottom of HSA