User guide
Panel Features
and Connections
This section of the user guide describes:
Front panel features
Rear panel features and connections
FOX Tx/Rx AV Front Panel Features
Figure 2 shows the front panel features of the FOX Rx AV. The FOX Tx AV is identical except
that the Follow LED is replaced by Auto (
b
) and it does not have a Loop-out LED (
d
).
FOX Rx AV
VIDEO FIBER OPTIC RECEIVER
COMPOSITE
FORMAT
S-VIDEO
COMPONENT
AUDIO
LOOP-OUT
FOLLOW
CONFIG
1 5
4
3
2
Figure 2. FOX Rx AV Front Panel Features
a Power LED — Lights green when the unit is receiving power.
b Video Format LEDs — These lights show signal presence and type. The receiver
indicates Composite, S-Video, Component, and Follow. The transmitter indicates
Composite, S-Video, Component, and Auto.
c Audio LED — Lights when the transmitter detects an audio signal at or above
35 dB below the nominal level. It stays on until the signal falls below this threshold
continuously for 10 seconds.
d Loop-Out LED — This LED is only on the receiver and indicates that the unit is in the
Daisy Chain mode.
e Cong Port — This 2.5 mm mini jack connector is an alternative to the rear panel
RS-232 connections for configuring the units, using SIS commands (see page 13) or the
FOX Extender Control Program (see page 19).
FOX Tx/Rx AV • Panel Features and Connections 4