Operating instructions

Confi guration and Operation, cont’d
DVCM 50 • Confi guration and Operation
3-8
PRELIMINARY
Taking a button out of macro mode
To take a button out of macro mode, follow these steps:
1. Place confi guration switch #1 on the rear panel in the On (up) position.
2. Press and hold the button that is in macro mode for 3 seconds. The orange E
LED blinks three times, then turns off.
3. Press the button again to confi rm that the orange E LED has turned off,
indicating the button is no longer in macro mode.
4. Set Confi guration switch #1 to Off.
Commands that have been programmed on the button are not erased when the
button is taken out of macro mode.
Removing commands from a button
If you want to delete a command that has been programmed onto a button, you
must remove all the commands programmed to that button. Follow these steps:
1. While the DVCM 50 is powered on, set confi guration switch #1 to On.
2. Press the DVD or VCR button to place the DVCM in the mode in which you
want the commands to be erased.
3. Press the button for which you want to delete commands, then within
2 seconds press the button again. The Learning LEDs turn off.
Example: If you want to erase the DVD player’s Play function from its Play
button, fi rst press the DVD button to ensure that the DVCM is in DVD mode.
Then, erase the Play function (and all other functions) from the Play button by
pressing it twice within 2 seconds.
4. Verify that the button’s commands were erased by pressing the button again.
If the commands have been erased, only LED #1 (the bottom LED) blinks; and
the other LEDs are off.
5. Repeat steps 1 through 3 for any additional buttons that you want to erase.
When fi nished, place switch #1 in the Off position (down).
To erase the commands from the DVD or the VCR button, press the button
twice: the fi rst time to switch to the desired mode; the second time to erase the
commands.
Confi guring using IR data transfer
You can also confi gure your DVCM 50 by transferring button confi guration data to
it from another confi gured DVCM 50 via the two IR LEDs on the back panels of the
DVCMs. With this method, you replicate (clone) the other DVCM’s confi guration
on your own unit without the use of software or cables.
To transmit confi guration data via IR, both the transferring and the receiving
DVCMs must be free of the wall, electrical box, or furniture. The DVCM that is
already confi gured must be powered by an external power supply, or by a power
supply shared with the unit that will be confi gured.
1. Ensure that all confi guration switches are set to Off (down) on both the
transmitting and the receiving units.
2. Apply power to both units.
3. Align the two units so that the IR Transmit and Receive LEDs of both DVCMs
are facing each other, and between 1 and 2 inches apart.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. [phone]
Fax [phone]
[e-mail]