User guide

System

Conﬁguration

This section describes the following:

• VNC 200 Web Interface

• Configuring a VNC 200 as an Encoder (Source)

• Configuring a VNC 200 as a Decoder (Display)

• Troubleshooting

VNC 200 Web Interface

Once all VNC 200 devices have been correctly set up for (and connected to) a network,

any further system configuration is achieved via the VNC 200 web interface. This contains

a number of pages which provide access to various system parameters.

TIP: This section provides step-by-step instructions for using the web interface and

is aimed at new users of the VNC 200 system. Advanced users may wish to

see Technical Data.

The web interface is “served up” by the VNC 200 device that was designated as

the controller during the network setup procedure (see “Setup and Connection

Procedure”). It can be viewed by any up-to-date web browser, running on a PC or a

laptop that is connected to the same network as the VNC 200 devices.

Suitable browsers include, but are not limited to:

• Microsoft

Internet Explorer (v6 and above)

• Firefox

, Mozilla

(v1.3 and above)

NOTE: Whatever browser is used, it must be configured to accept cookies and

be JavaScript-enabled. For further help on configuring your browser, see

“Browser Configuration”.

Accessing the web interface

1. Enter the IP address of the controller device into the address bar of the web browser,

for example, http://192.168.0.18. The following web page illustration appears in

the web browser.

VN-Matrix 200 Series • System Configuration 24