User Guide User guide

Installation and
Setup
This section describes how to connect applicable cables to the MTP 1500RL 15HD RS SEQ
receiver.
It covers:
z Rear Panel Features
z Power Supply Wiring
z TP Cable Termination
Rear Panel Features
The illustration below shows the rear panel of the MTP 1500RL 15HD RS SEQ receiver.
INPUT
BUFFERED OUTPUT
POWER
12V
1.0A MAX
MTP 1500RL 15HD RS SEQ
MTP
RS-232
RxTx
OUTPUT
MTP
ON
H + V + CSYNC
SOG VIDEO END BI-232
MTP
MTP
5
6
1
2
4
3
Figure 3. MTP 1500RL RS SEQ Receiver Rear Panel Features
a Power connector — Plug the included external 12 VDC, 1 A, power supply into this
2-pole captive screw connector. See “Power Supply Wiring” section for wiring details.
CAUTIONS: • Always use a power supply supplied or specied by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification
and may cause damage to the supply and the end product.
• Unless otherwise stated, the AC/DC adapters are not suitable for use in
air handling spaces or in wall cavities.
• The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75 and the
Canadian Electrical Code part 1, section 16.
• The power supply must not be permanently fixed to building structure
or similar structure.
b Input connector — Connect one end of the twisted pair cable from an MTP transmitter
to this RJ-45 connector (see “TP Cable Termination” to wire the connector).
CAUTION: Do not connect these devices to a computer data or telecommunications
network.
c Buffered output connector — Connect up to 5 daisy-chained MTP receivers to
this RJ-45 connector.
MTP 1500RL 15HD RS SEQ• Installation and Setup 4