User Guide User Manual
MTP AV Series • Installation 6
Setting the Jumpers on AAP Transmitters
1. Remove and retain the two screws that secure the back cover to the MTP (see figure 5).
12V
0.5A MAX
OUTPUT
POWER
− +
1. Remove these Screws 2. Carefully pull the RJ-45 connector
through this hole.
Figure5. Removing the MTP Cover
2. Pull the cover out of the way, carefully twisting the RJ-45 connector as necessary to
slide it through the hole in the cover marked “Output.”
3. Remove and retain the two standoffs that secure the audio board to the main (video)
board (see figure 6). Lift the audio board out of the way.
Remove these standoffs.
Figure6. Removing the Audio Board
4. Locate the jumper block (see figure 7) on the video board. Shift the jumper to the
alternate location.
Mono (default jumper position)
Compatible with new model receivers.
Cannot remotely power receiver
Stereo
Compatible with old model receivers.
Can remotely power receiver.
Figure7. Video Board Jumper Locations
5. Replace the audio board and secure it in place with the standoffs (removed in step 3).
6. Feed the RJ-45 connector through the hole in the cover marked “Output” and replace
the cover. Secure the cover in place with the two screws (removed in step 1).
ATTENTION: Ensure that the TP cable is not pinched when you reinstall the cover.