User Guide User Manual

MTP AV Series • Installation 9
Transmitter and Receiver Throughput Connections
Figure 12 identifies the connections between the transmitter and receiver.
12V
0.5A MAX
OUTPUT
POWER
− +
MTP Transmitters MTP Receivers
INPUT
LR
MTP T AV
OUTPUT
VIDEO
12V
0.5a
INPUT
MTP T SV A RCA
OUTPUT
MAX
12V
0.5a
MAX
S-VIDEO
LR
OUTPUT
MTP R SV A RCA
INPUT
S-VIDEO
12V
0.5a MAX
OUTPUT
MTP R AV
LR
INPUT
VIDEO
12V
0.5a MAX
R
L
1 1
1
Figure12. Throughput Connections
ATTENTION: Do not connect these devices to a computer data network or a
telecommunications network.
NOTE: RJ-45 termination must comply with the TIA/EIA T 568A or TIA/EIA T 568B
wiring standards for all connections (see figure 13).
a Transmitter output and receiver input connector — Connect one end of a TP cable
to this RJ-45 female connector on the transmitter. On the MTPTAV AAP, the connector
is at the end of a short pigtail.
Connect the free end of the same TP cable from the transmitter to the RJ-45 female
connector on the receiver.