User guide

k
DIP switches (RL receivers only) — A 5-pole DIP switch is used to configure the
features of the MTP receivers.
•• Horizontal sync (H Sync +) switch — Set this switch On (up) for positive
horizontal sync or Off (down) for negative sync.
•• Vertical sync (V Sync +) switch — Set this switch On (up) for positive vertical
sync or Off (down) for negative sync.
NOTE: Most devices use negative sync for H Sync and V Sync.
•• S-Video switch — This switch is used to set which pins of the 15-pin HD
connector S-video is output on.
•• Set this switch On (up) to output chroma on pin 3 and luma on pin 2.
•• Set this switch Off (down) to output chroma on pin 1 and luma on pin 2.
•• End Unit switch — Set this switch On (up) if either of the following is true:
•• The receiver being configured is the only receiver connected to the transmitter.
•• The receiver being configured is the last receiver in a daisy-chained system.
Set the End Unit switch Off (down) on the receiver being configured if there are one
or more receivers connected to the Buffered Output RJ-45 connector (see
figure 6,
c
).
MTP 15HD A Series • Installation and Operation 8