User guide

SMX System MultiMatrix Switcher • Installation and Cabling 12
Wiring the Audio Connectors
Connect audio input devices to the 3.5 mm, 5-pole captive screw connectors (up to two
groups of eight sets possible).
Wire the input connectors as shown in figure 5.
Unbalanced Stereo Input
Balanced Audio Output Input
Tip
Ring
Tip
Ring
Slee
ves
Tip
Sleeve
Sleeve
Tip
Unbalanced Mono Input
Balanced Mono Input
(high impedance)
Tip
Ring
Sleeve
Tip
Sleeve
LR
LR
LR LR
Do not tin the wires!
Figure 5. Captive Screw Connector Wiring for Audio Signals
NOTE: When making connections for the SMX from existing audio cables (see
figure 7). A mono audio connector consists of the tip and sleeve, whereas a stereo
audio connector consists of the tip, ring, and sleeve. The tip, ring, and sleeve wires are
also shown above on the captive screw audio connector diagram (balanced inputs, see
figure 6).
Tip (+)
Sleeve ( )
Sleeve ( )
Ring ( - )
Tip (+)
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Figure 6. RCA Audio Connectors
Wire the output connectors as show in figure 7.
Balanced Audio Output
Tip
Ring
Tip
Ring
Slee
ves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Do not tin the wires!
Figure 7. Captive Screw Connector Wiring for Audio Output
CAUTION: For unbalanced audio, connect the sleeves to the center contact ground.
Do not connect the sleeves to the negative (-) contacts.