User Guide User guide
Operation, cont’d
MVX Plus 128 VGA A Matrix Switcher • Operation
3-6
PRELIMINARY
f
Esc (
>
) button — The Esc (
>
) button has two primary functions (•) and eight
secondary functions (❏):
• Cancel operations or selections in progress and reset the front panel
button indicators.
N
The Esc (
>
) button does not reset the current configuration, the RGBHV button
and Audio selection button, any presets, or any audio gain or attenuation or
volume settings.
• Flashes once to indicate that the escape function has been activated.
❏ In the I/O Group mode, select group 4. See “I/O grouping” on page 3-19.
❏ In the I/O Group mode, indicate that group 4 is selected. See “I/O
grouping” on page 3-19.
❏ Increase the RGB delay of switches to the selected output. See “Setting
RGB delay” on page 3-23.
❏ Increase the audio level of the selected input. See “Viewing and adjusting
the input audio level” on page 3-32.
❏ Increase the volume of the selected output. See “Viewing and adjusting
the output volume” on page 3-36.
❏ With the Enter, Preset, and View buttons, select Serial Port Configuration
mode. See “Selecting the rear panel Remote port protocol and baud rate”
on page 3-43.
❏ Select 115200 baud for the RS-232/RS-422 port in Serial Port Configuration
mode. See “Selecting the rear panel Remote port protocol and baud rate”
on page 3-43.
❏ Indicate that the RS-232/RS-422 port is set to 115200 baud in Serial Port
Configuration mode. See “Selecting the rear panel Remote port protocol
and baud rate” on page 3-43.