User Guide User guide

3-21
MVX Plus 128 VGA A Matrix Switcher • Operation
PRELIMINARY
Example 5: Grouping inputs and outputs
In the following an example, several switcher inputs and outputs are assigned to
groups. The steps show the front panel indications that result from your action.
1. Press and release the Esc button (figure 3-28).
C O N T R O L
PRESET ENTER
ESCVIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-28 — Clear all selections
2. To enter I/O Group mode, press and hold the Input 1 and Output 1 buttons for
approximately 2 seconds and then release the buttons (figure 3-29).
1
1
1
2
3
3
1
2
3
Press and hold the Input 1
button and Output 1 button.
Release the Input 1 button
and Output 1 button.
Ungrouped input and
output buttons light.
2 seconds
Figure 3-29 — Select I/O Group mode
3. Press and release the Enter button to select group 1 (figure 3-30).
C O N T R O L
PRESET ENTER
ESCVIEW
Press and release the Enter button to select group 1.
The button lights amber to indicate the selection.
1 32 4Group #
Figure 3-30 — Select an I/O group
N
I/O groups are protected when front panel lock mode 2 is selected. You can view
the groups in lock mode 2, but you cannot change them from the front panel.
If front panel lock mode 2 is selected and you try to perform step 4, the actions
are ignored and the Enter, RGBHV, and Audio buttons flash.