User Guide User guide

3-27
MVX Plus 128 VGA A Matrix Switcher • Operation
PRELIMINARY
Example 7: Saving a preset
In the following example, the current configuration is saved as a preset. The steps
show the front panel indications that result from your action.
1. Press and release the Esc button (figure 3-40).
C O N T R O L
PRESET ENTER
ESCVIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-40 — Clear all selections
2. Press and hold the Preset button for approximately 2 seconds until it blinks
(figure 3-41).
PRESET PRESET
1
2
3
Press and hold the Preset button until it blinks.
2 seconds
= Blinking button
All input buttons with assigned presets light red.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Red
(Preset Assigned)
Unlit
(No Preset Assigned)
Figure 3-41 — Enter Save Preset mode
3. Press and release the input or output button for the desired preset
(figure 3-42).
C O N T R O L
PRESET ENTER
ESCVIEW
INPUTS
1
2
3
4
5
6
7
8
9
The Enter button blinks to
indicate the need to save the
preset.
The Preset button continues
to blink.
= Blinking button
Press and release the Input 1 button.
The button blinks red to indicate that this
preset number is selected but not saved.
Figure 3-42 — Select the preset
4. Press and release the Enter button (figure 3-43). The current configuration is
now stored in the selected memory location.
C O N T R O L
PRESET ENTER
ESCVIEW
The Enter and Preset
buttons return to unlit or
background illumination.
Press the Enter button to
save the preset.
All input buttons and output
buttons return to unlit or
background illumination.
Figure 3-43 — Press the Enter button