User Guide User guide

Programmer’s Guide, cont’d
MVX Plus 128 VGA A Matrix Switcher • Programmer’s Guide
4-18
PRELIMINARY
Command/response table for IP SIS commands
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
IP setup commands
Set matrix name
EX3)
CN
}
Ipn•
X3)]
Read matrix name (location
E
CN
} X3)]
Reset matrix name to
factory default
E
•CN
}
Ipn•
X3)]
Set time and date
EX3@
CT
}
Ipt
X3@]
Read time and date
E
CT
} X3#]
Set GMT offset
EX3$
CZ
}
Ipz
X3$]
In the command, the divider
between hours and minutes
can be either a colon or a
period. In the response, the
divider is a colon.
Example:
E
8.0CZ
}
Ipz+08:00
]
Set Daylight Savings Time
EX3%
CX
} X3%]
Read Daylight Savings Time
E
CX
} X3%]
Set IP address
EX3^
CI
}
Ipi
X3^]
Read IP address
E
CI
} X3^]
Read hardware address
E
CH
} X3&]
Read # of open connections
E
CC
} X3*]
Set subnet mask
EX3^
CS
}
Ips
X3^]
Read subnet mask
E
CS
} X3^]
Set gateway IP address
EX3^
CG
}
Ipg
X3^]
Read gateway IP address
E
CG
} X3^]
Set administrator password
EX3(
CA
}
Ipa•
X3(]
Read administrator
password
E
CA
} X3(]
Reset (clear) administrator
password
E
•CA
}
Ipa•
]
Set user password
EX3(
CU
}
Ipu
•X3(]
Read user password
E
CU
} X3(]
Reset (clear) user password
E
•CU
}
Ipu
•]
Set mail server,
domainname
EX3^
,
X4)
,
X3(
CM
}
Ipm
X3^
,
X4)
,
X3(]
Read mail server,
domainname
E
CM
}
X3^
,
X4)
,
X3(]
Set e-mail recipient
EX4!
,
X4@
CR
}
Ipr
X4!
,
X4@
,
]
This command sets the
recipient. To receive e-mail
notifications, you must then
set the events that the switcher
reports, using one or more
separate Set e-mail events (EM)
commands (see next page).
Example:
E
72,[e-mail]
}
Ipr72,[e-mail],
]
Read e-mail recipient
EX4!
CR
}
X4@
,
]