Setup Guide Instruction Manual

ManualsBrandsExtron Electronics ManualsAcousticsP-2 DA2 WM F, WM F AAP, EC F, D

Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D

This guide provides basic instructions for an experienced

installer to set up and operate the Extron

P/2 DA2 WM F, WM F AAP, EC F, D Series of

distribution ampliﬁers.

Installation

These distribution ampliﬁers are high performance one input, two output video devices with

audio that accept video input from a VGA-QXGA compatible PC and distributes that signal to

separately buffered outputs. Refer to the user manual for speciﬁc mounting instructions. An

example application for the P/2 DA2 D is shown below. Refer to the user manual for other

application and installation examples.

COMP

UTER IN

MONIT

OUT

AUDI

O IN

Projector

Extron

MHR-5 Cable

PC w/ Audio

Extron

P/2 DA2 D

Distribution Amplifier

Audio

Output

Extron

MPA 122

Mini Power Amplifier

POWER

12V

3A MA

OUTP

UTS

4/8 Ohms SPEAKERS

INPUT

REMO

10V

VOL/MUTE

MPA

122

Extron

SI 3CT LP

Full-Range Ceiling

Speakers

Installation and service must be performed by authorized personnel only.

Step 1 — Power down

Power off the display device, the PC and its local monitor.

Step 2 — Connect inputs

• For video input, connect the VGA output of the PC to the Input or Computer In 15-pin

HD connector on the faceplate of the distribution ampliﬁer.

• For unbalanced stereo audio input, connect the input device

to the 3.5 mm female audio jack on the faceplate of the

distribution ampliﬁer. Wire the audio plug as shown on the

right.

Step 3 — Connect outputs

• If a local monitor is being used, connect the monitor of the PC to the Buffered Local

Monitor or Monitor Out 15-pin HD output connector on the faceplate of the distribution

ampliﬁer.

(Continued on reverse side)

Sleeve ( )

Ring (R)

Tip (L)

Summary of content (2 pages)

PAGE 1
Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D This guide provides basic instructions for an experienced installer to set up and operate the Extron® P/2 DA2 WM F, WM F AAP, EC F, D Series of distribution amplifiers. Installation These distribution amplifiers are high performance one input, two output video devices with audio that accept video input from a VGA-QXGA compatible PC and distributes that signal to separately buffered outputs. Refer to the user manual for specific mounting instructions.
PAGE 2
Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D • Connect the display device to the 15-pin HD connector on the rear panel of the P/2 DA2 WM F, WM F AAP, EC F or to the 5 BNC connectors on the rear panel of the P/2 DA2 D. • For audio output, connect the audio output device to the 3.5 mm direct insertion 5-pole connector on the rear panel of the distribution amplifier. See the diagram below. R Right Tip Ring Sleeve(s) Tip Ring Unbalanced Stereo Output Left R Left L L Tip NO GROUND HERE.