User guide

Symbol definitions for receiver SIS commands
] = Carriage return/line feed
} = Carriage return (no line feed)
| = Pipe (can be used interchangeably with the } character)
• =space
E = Escape key
W = Can be used interchangeably with the E character
X( = Mute or auto memory status and enable or disable status 0 = off or disable 1 = on or enable
X1) = Link and input status 0 = link or input not detected 1 = link or input detected
X1! = Internal temperature nnnF•nnC
X1@ = Transmission mode SM = singlemode MM = multimode
X1# = Firmware version v.vv
X1$ = Sync frequency xxx.xx (frequency in kHz [H] or Hz [V])
X1% = Horizontal and vertical position 000 through 255
X1^ = Memory preset number 01 through 30
X1& = Test pattern 0 = none 2 = grayscale
1 = color bars 3 = alternating pixels
X1* =
Rx link and daisy chain enable
0
= disable
2
= daisy chain enable
1
= return link enable
X1( = Video bit depth 0 = auto 1 = 8-bit
X2) = Video delay (0 plus six steps at 0.25 seconds per step) 0 = 0 second
1 = 0.25 second 4 = 1.0 second
2 = 0.5 second (default) 5 = 1.25 second
3 = 0.75 second 6 = 1.5 second
X2! = Switch position 0 = off (right) 1 = on (left)
Command and Response Table for Receiver SIS Commands
Command ASCII Command
(Host to Unit)
Response
(Unit to Host)
Additional Description
Video mute
Mute output
1B
Blk1
]
Blank the video output.
Unmute output
0B
Blk0
]
Output video.
Show video mute status
B
X(]
Video mute status is
X(
.
Horizontal shift
Set a horizontal position
X1%
H Hph
X1%]
Set horizontal centering to
X1%
.
Increment position
+H
Hph
X1%]
Shift the image one pixel to the right.
Decrement position
–H
Hph
X1%]
Shift the image one pixel to the left.
Show position
H
X1%]
Vertical shift
Set a vertical position
X1%
/ Vph
X1%]
Set vertical centering to
X1%
.
Increment position
+/
Vph
X1%]
Shift the image down one line.
Decrement position
–/
Vph
X1%]
Shift the image up line.
Show position
/
X1%]
List sync frequency
View input frequency
1LS
X1$
horizontal
,
X1$
vertical
]
Shows horizontal frequency in kHz and vertical
frequency in Hz. 000.0,000.0 if no signal is
detected.
Memory presets
Save preset
X1^
, Spr
X1^]
Command code is a comma.
Recall preset
X1^
. Rpr
X1^]
Command code is a period.
NOTE: X( = Mute and auto memory status 0 = off 1 = on
X1$ = Horizontal and vertical position 000 through 255
X1% = Sync frequency xxx.xx (frequency in kHz [H] or Hz [V])
X1^ = Memory preset number 01 to 30
PowerCage FOX HDMI • Remote Control 23