Operating instructions

Operation, cont’d
CrossPoint Plus Matrix Switchers • Operation3-10
Example 4: View video and audio, audio-only, and video-only ties
See figure 27, figure 28, figure 29, and figure 30 and the following steps for an
example of viewing the video and audio, audio-only, and video-only ties in the
current configuration.
Example 4 shows the process of viewing the current configuration after the
steps in Examples 1, 2, and 3 have been performed.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC
ESC
RGBHV AUDIO
VIEW
12
8
CONTROL I/O
A
B
C
RGBHV AUDIO
C
LED key: = off, = on,
= on for 2 seconds, then off
2
2
2765
Figure 27 — Example 4: Viewing the current configuration, no input
selected
A
Press and release the Esc button. The Esc LED turns on for approximately
2 seconds and turns off.
B
Press and release the View button to enter view-only mode. The View LED
lights. With no input LED selected, all output LEDs that have no established
ties light.
D
Press and release the input 5 button (figure 28). The input 5 LED lights.
If ties are established for input 5, all output LEDs toggle; outputs with no ties
turn off and the LEDs associated with all outputs tied to input 5 (audio, video,
or audio and video ties) light. If no ties are established for input 5, all output
LEDs turn off.
If audio is broken away, the Audio LED blinks.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
D
RGBHV AUDIO
B
LED key: = off, = on, = blinking
1843
D
5
D
B
Figure 28 — Example 4d: Viewing the current configuration, video and
audio
A set of ties can also be viewed by selecting a tied output. To demonstrate this,
note the number of a lit output LED and press and release the output button