Operating instructions

Programmer’s Guide, cont’d
CrossPoint Plus Matrix Switchers • Programmer’s Guide4-6
Command/response table for SIS commands (Cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Start direct write of global presets
Esc
P
Xb
Write Preset
Xb
Ready Allows direct entry of presets.
{Tie commands} {Define ties for preset.}
End direct write of global presets
Esc
p End Write Preset
Xb
Saves directly written presets.
Quick recall preset
Esc
. Rpr
Xb
Command character is a period.
1. This sequence of commands forces the switcher to perform a complete backplane switch
within 60 msecs of receipt of the Quick recall command.
2. The switcher ignores any invalid command or non-switching commands received between
the Start and End commands.
3. If there is no activity for 5 seconds, the switcher returns the timeout (E17) error.
4. The switcher disables front panel switching during this sequence of commands.
5. The switcher returns the invalid command (E10) error if it receives the End command
without the start command or the Quick recall command without a prior direct preset write.
6. The switcher must receive the Quick recall command within 100 msecs of the End
command.
Example:
Esc
P14 Write Preset 14 Ready Creates new preset 14 with:
1*3! A & V Input 1 tied to output 3.
7*8% Video input 7 tied to output 8
1
.
10*4& RGB input 10 tied to output 4
1
.
12*4$ Audio input 12 tied to output 4.
Esc
p End Write Preset 14 Stops entry, saves preset 14.
Esc
. Rpr
Xb
Recalls the preset.
Executive mode
Lock front panel X Exe1 Enable executive mode.
Unlock front panel x Exe0 Disable executive mode.
Resets
Reset global presets
Esc
zG ZapG•• Clear all global presets.
Reset delays
Esc
zD ZapD•• Reset all switch intervals to 0 sec.
Reset audio levels
Esc
zA ZapA•• Reset all audio levels to 0dB.
Reset grouping
Esc
zP ZapP•• Reset all I/O grouping.
Reset whole switcher
Esc
zXXX ZapXXX Clears all ties and globalpresets,
the RGB delay, the I/O grouping,
and resets all audio gains to 0dB.
View ties, gain, and presets
View video output tie V/v
X2
% Out
X2
•In
X3
•Vid
Example: v7% Out07•In02•Vid Output 7 video tied to input 2
video.
View audio output tie V/v
X2
$ Out
X2
•In
X3
•Aud
Example: V3$ Out03•In06•Aud Output 3 audio tied to input 6
audio.
View gain for input V/v
X1
GIn
X1
•Aud=
X9
Example: v4G In04•Aud=-02 Gain for input #4 is -2dB.