Setup guide

TLP 350CV Cable Cubby • Setup Guide

TLP 350CV Setup Guide, Continued

Step 1 — Obtain cutout dimensions

Determine the optimum location for the TLP 350CV keeping in mind the size of the enclosure that will be below the

table and also the ease of operation for a user. Cutout dimensions are available as a router guide, printed dimensions

and a cutout template. If using the router guide, follow the instructions included with it. Printed dimensions are

available in the Appendix of the TLP 350CV User's Manual available on the included DVD or at www.extron.com.

Make certain the correct cutout dimensions are being used before proceeding to the next step.

Extron is not responsible for improperly positioned Cable Cubby models.

Wear safety glasses when operating power equipment. Failure to comply can result in eye injury.

Double-check before you cut:

c If using a routing template, be certain the correct template for the TLP 350CV is being used.

c If using a CNC router, be certain the correct dimensions for the TLP 350CV are entered.

c If using a reciprocating saw or jigsaw, be certain the correct paper template for the TLP 350CV is

being used.

c Be certain the cut is laid out in exactly the desired location.

c Be certain the cut is laid out so the connector access side is oriented as desired.

Step 2 — Cut the surface

After verifying and checking dimensions, cut a hole in the surface of the furniture where the enclosure will be

installed. See "Preparing the Table" in chapter 2 of the TLP 350CV User’s Manual.

The opening in the table for the Cable Cubby should be cut only by licensed and bonded craftspeople. Exercise

care to prevent scarring or damaging the furniture.

The surfaces of the Cable Cubby enclosure have screws and other protruding hardware that could damage ﬁne

furniture. Do not rest the enclosure on unprotected furniture.

Ensure the table surface is at least 3/8 inch (0.375 in) (0.95 cm) thick.

There are three methods for cutting the hole in the table:

• Hand router,

• CNC wood cutter, and

• reciprocating saw or jigsaw

A hand router using the routing template or a CNC wood router are the most accurate, preferred, and recommended

methods for preparing the table for the TLP 350CV.

RECOMMENDED — A hand router and the Extron TLP 350CV routing template, part #70-694-01. Refer to the

Routing Template User’s Manual, available on the Extron Web site, www.extron.com, to prepare the template and

use the template to cut the hole.

The metal router guide is reusable. Do not discard this router guide when the installation is complete.

RECOMMENDED — A CNC wood router and the exact cut-out dimensions:

7.50 +0.00/-0.02 in W x 6.00 +0.00/-0.02 in D

(19.05 +0.00/-0.05 cm W x 15.24 +0.00/-0.05 cm D)

The underlined dimension is the unit’s connector or AAP access side.

Acceptable — A reciprocating saw or jigsaw and a paper cut-out template (available on the Extron Web site,