Setup guide

5
TLP 350CV Cable Cubby • Setup Guide
Step 8 — Connect the external supply
Connect the two pole, 3.5 mm captive screw connector from the power
supply (provided with the unit) to the power supply socket on the rear
panel (
a
). The power supply provides 12 VDC and 1.0 A.
Step 9 — Connect to a LAN
Using a standard ethernet cable, connect the TLP 350CV to
the network via the LAN port (
b
). The TLP 350CV must be
connected to the same network environment as the assigned
IP Link controller.
N
For graphic user interface configuration, a PC may be
directly connected to the TLP 350CV with an ethernet
crossover cable.
Step 10 — Connect preview inputs
Two BNC connectors carry video from a composite or S-video source allowing a
TLP 350CV user to preview video from that source. Composite video is connected to
Vid/Y (
c
). For S-video, the luma signal is connected to Vid/Y (
c
) and chroma to C (
d
).
POWER
12V
1.0A MAX
LAN
VID / Y C
PREVIEW INPUT
a b c d