User guide

Wall Mounting the TLP 710MV with a Wall Box
The TLP 710MV can be wall mounted using the Extron BB 710M (part number 70-971-01)
or the Extron EWB 710M (part number 70-950-0x). Follow the instructions provided with
the appropriate wall box.
Desktop Mounting the TLP 710TV
Placement without a Mounting Kit
The TLP 710TV comes assembled with a stand that allows it to be placed on a desktop.
To secure the unit to the desktop:
Mounting Holes (2)
Figure 43. TLP 710TV Base, Showing Mounting Holes
1. Mark the location of two holes, 3.07 inches (78 mm) apart.
2. Drill two holes through the desktop from underneath.
3. Attach the TLP 710TV, using two #8 wood screws through the desktop from
underneath into the two holes in the base.
Swivel Mount Adapter
The TLP 710TV can be mounted with the optional Extron SMA-1 swivel mount adapter.
This allows the unit to be mounted permanently yet swivel up to 180° in either direction.
1. Remove the back cover and base cover, using the provided Extron removal tool, as
described in “Removing the TLP 710TV Base for VESA Mounting“ on the next
page.
2. Remove the screw holding the locking plate at the bottom of the base. This releases
the weight, which can be removed from the top of the base, leaving the mounting
hole that will fit over the conduit of the SMA-1.
Locking ScrewLocking Plate
Figure 44. TLP 710TV Base, Showing Locking Plate and Screw
3. Attach the conduit, insulation disk, and swivel disk and configure the set screws to
allow for the degree of swivel that is required (see the SMA-1 Swivel Mount Adapter
Kit User Guide, available at www.extron.com).
4. Place the mounting hole in the base over the conduit of the SMA-1.
5. Secure the unit with the backing plate and locking nut as described in the SMA-1
Swivel Mount Adapter Kit User Guide.
TLP 710MV and TLP 710TV • Mounting 44