User guide

3. If necessary, cut the zip tie holding the twisted pair cables to the TLP 710TV base.
4. If necessary, remove the cables from the cable runway in the base.
5. Remove the four spanner drive security screws holding the hinges to the touchpanel.
NOTE: The spanner drive screws holding the hinges require a #6 spanner bit or
#6 spanner head screwdriver, which is not provided.
VESA Mounting the TLP 710TV
1. Before attaching the VESA mounting kit, remove the base and back of the TLP 710TV,
as described in the previous section.
2. If necessary, connect the cables and zip tie them to the back of the touchpanel.
3. Attach the small back cover (provided). Fit the bottom catches into the slots on the
bottom of the panel and snap the side catches into place.
4. Secure a VESA D 75 mm mount kit to the back of the TLP 710TV. The photograph
below shows the Extron LPVM-1 mount kit (part number 60-1099-02). Follow the
instructions provided with the mounting kit.
LPVM-1 Plate 2
Security Screws (4)
Small Back Cover
Figure 47. VESA Mounting the TLP 710TV with the LPVM-1
TLP 710MV and TLP 710TV • Mounting 46