User Guide Rev. D User Manual

VTG 300/300R • OperationVTG 300/300R • Operation
Operation, cont’d
Additional Functions
In addition to the main menu system, there are several other
functions that are featured by the VTG. A low battery warning
message and a button lock mode that locks out all front panel
buttons except the power button are also featured.
Low Battery mode
When the batteries in the VTG are low and the external power
supply is not connected, the message “Warning: Battery Low!”
flashes on the LCD for one second every 30 seconds. To end
this cycle, the external power supply needs to be connected or
the batteries need to be recharged or replaced. See Installing the
VTG 300 Batteries in this chapter.
Power
on
60-543-01
FW Ver. 1.00
EXTRON
VTG 300
* WARNING: *
BATTERY LOW!
VGA 31.5kHz
640x480 @60
3 sec.
3 sec.
3 sec.
AUDIO LEVEL
-10dBu 245mV
AUDIO FREQ.
800 Hz
Figure 2-9 — Low battery warning mode
Button Lock mode
To prevent accidental changes to settings, simultaneously press
and hold the Signal and the Test Patterns buttons for two
seconds to enable the VTG’s Button Lock mode. See the
following menu flowchart. Button Lock mode locks all front
panel buttons except Power. When Button Lock mode has been
enabled, the message “Button Lock Enabled” is displayed for 2
seconds before the VTG returns to the default cycle.
2-152-14
still set on) after 2 seconds of button inactivity, but will light
again when any button is pressed.
When the VTG is powered by both the external power
supply and batteries, the external power supply provides
the power, not the batteries.
Unit Reset submenu (Press & Hold)
The VTG can be reset to factory default values. Any of the
adjacent and button pairs (Level, Frequency, or Rate) will
activate the reset.
Press and hold both
and buttons simultaneously for two
seconds to reset the VTG to its factory defaults.
• The message “Unit Reset to Factory Defs” will be
displayed.
Exit menu
The following flowchart describes the Exit menu.
Pressing the Next button from this menu will return you to the
default menu cycle.
AUDIO
SETUP
MENU
MENU
VIDEO
SETUP
MENU
ADVANCED
SETUP
MENU
NEXT
MENU
TO EXIT MENU
PRESS NEXT
60-543-01
FW Ver. 1.00
EXTRON
VTG 300
VGA 31.5kHz
640x480 @60
3 sec.
3 sec.
3 sec.
AUDIO LEVEL
-10dBu 245mV
AUDIO FREQ.
800 Hz
Figure 2-8 — Exit menu