Safety data sheet

Page 5/9
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 29.10.2018 Revision: 27.02.2018Version number 4
Trade name: Extron Spray various colours 400ml (339967, 339974, 339998, 340000, 340024, 340031, 340048,
340055, 455070- 455186)
(Contd. of page 4)
48.0
Not necessary if room is well-ventilated.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use self-contained respiratory protective device.
·
Protection of hands:
In case of contact with spray dust protective gloves made of butyl shoud be used (min. 0.4 mm thick), e.g.
KCL Camatril, article no. 898 or similar products
Solvent resistant gloves
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
Butyl rubber, BR
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
Butyl rubber gloves with a thickness of 0.4 mm are resistant to:
Acetone: 480 min
Butyl acetate: 60 min
Ethyl acetate: 170 min
Xylene: 42 min
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact in work areas without heightened risk of injury (e.g. Laboratory) gloves made
of the following material are suitable:
Natural rubber, NR
·
Eye protection:
Tightly sealed goggles
·
Body protection:
Light weight protective clothing
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Aerosol
Colour:
According to product specification
·
Odour:
Characteristic
·
Odour threshold:
Not determined.
·
pH-value:
Not determined.
·
Change in condition
Melting point/freezing point:
Undetermined.
Initial boiling point and boiling range:
Not applicable, as aerosol.
·
Flash point:
Not applicable, as aerosol.
·
Flammability (solid, gas):
Not applicable.
·
Ignition temperature:
365 °C (689 °F)
(Contd. on page 6)
GB