Operating Manual

9
Mounting
The iTAG X30 comes complete with a stainless-steel clip which can be used to
clip to PPE or used with a lanyard.
Simple configuration
The iTAG X30 Firmware contains 7 pre-defined configurations, which can be
activated quickly and easily using the TED and Tag Manager BD.
Motion sensor
The iTAG X30 contains on-board motion sensors. When the tag is configured to
a profile which utilises the motion sensor it will enable different transmission
intervals of the tags whether the tag is stationary or in motion, reducing
unnecessary network traffic and conserving battery.
Integrated access control
Minimise the number of ancillary products being carried by using integrated
access control to gain access to site. Easily identify workers due to Photo ID
being visible on the front of the tag.
Rugged performance
The iTAG X30 tag enclosure has been designed for durability with IP rating of
IP65 and IP67 to ensure complete confidence in the product when in harsh
environments.
4 Tag usage instructions
4.1 Before using the tag
Please check for damage to the tag, clip and charging cable prior to using the tag.
Check firmware is latest version and update if required.
4.2 Configuring and updating the tags
Tag Manager BD is used to configure the tag. Refer to separate user guide for
general instruction on the use of Tag Manager BD.
4.2.1 Initial Start
Detect tags etc…..