Technical data

Operating Manual
4
1 Introduction
The iCAM100 is designed for use in Hazardous areas where a method of surveillance
is required and space is at a premium. It is also ideal for monitoring plant or areas
which are difficult to view due to its compact size. The iCAM100’s design means that it
is suitable for use in both Zone 1 and Zone 2 environments.
Please read the installation and operating instructions from cover to cover before
installing and commissioning the iCAM100. Only Qualified personnel that are authorised from
the operating company should install the iCAM100 unit.
Validity of Operating and Programming Instructions
• Your Extronics agent will be able to give you information about any improvements or
modifications.
• If the iCAM100 is damaged by inappropriate use, the manufacturer will not guarantee
the product.
Operational Safety
• The iCAM100 Module is assembled on our ISO 9000 accredited premises and
therefore conforms to the appropriate requirements.
• The front of the actual camera housing is protected to IP 66. The termination
enclosure is rated to IP 65.
• If the iCAM100 is not used in a manner for which it is design or if it is not installed
as directed, there will be a certain level of risk involved for which Extronics Ltd will
not be responsible.
Repairs, Dangerous Chemicals
A note describing the fault must always accompany equipment sent to Extronics Ltd for
repair.
Important! The following procedures must be carried out before the iCAM module is
returned for repair:
• Remove all residues that may be present. Pay special attention to the gasket grooves
and crevices where residue may collect.
• Please ensure that full precautions have been taken to remove all traces of
substances that may represent a health risk before returning any equipment.
Costs of disposal of materials or of injury to personnel (acid burns etc.) arising
because of defective cleaning of the equipment will be charged to the owner of the
equipment.