Technical data

Operating Manual
7
3 Installation & Setting To-Work
The iCAM100 is very simple to install and can either be secure directly to suitable surface
using the mounting holes on the module, or using the included wall bracket
3.1 Wiring
Remove the iCAM100 lid by undoing the four screws (being careful not to loose the
washers).
Inside you will find a terminal block with four wires going to the camera unit, one twisted pair
for power to the camera & one twisted pair for the video signal.
Using a suitable cable feed through the gland connect the wires to the terminal block as
shown in the diagram.
Note: For 3 wire Camera Modules the Black wire is common for both the 0V
Supply and the –Video Signal
Yellow & Black for composite output
Pink & Yellow for Differential output
Earth terminal for incoming earth on some models
Once the terminal wires have been connected, tighten the gland and replace the lid
accordingly.
Important Ensure the correct Cable and Cable Gland are used and that the unit is
suitably earthed for your particular application