User guide

Operating Manual
2.3 Powering On / Off
Information The iCAM501U must be fully powered on before plugging a USB cable
into the camera or to take a picture. This will be indicated when the
green LED has stopped flashing.
Green LED will flash rapidly for ~10
seconds while the camera boots.
The Blue and Red LED will flash
briefly during boot up. The Green
LED then goes solid when ready for
operation. If the green LED flashes
slowly after booting, this indicates a
low battery level.
Press and hold the “FLASH”
and “RECORD” buttons
simultaneously until the “ON”
LED starts to flash green.
The diagrams above show how to power on the iCAM501U. The same procedure is
required to turn the iCAM501U off. Once it is turned off no LED’s should be lit.
2.4 Setting Time and Date of the iCAM501U
The iCAM501U has an internal clock which is used to time code the JPEG file with
information on when a picture and audio file was taken. The internal clock will have
been set to GMT when the camera was manufactured. However, if it has been stored
for a significant time without batteries, the internal clock may need to be set when the
7