User guide

Operating Manual
2.5.2 Enabling the Flash
Once the flash button is
pressed the red LED will start
to flash, after some seconds
the LED will become solid
indicating the flash has
charged and is ready for use.
The green LED may also flash
slowly if the battery level is
lo
w
Press the “FLASH”
button to enable the flash
feature of the camera.
To take a picture move your eye to the view finder and position the camera so that
you can see what it is you would like to take a picture of, the point of interest should
be at least 30cm from the lens. The reticule can be used to frame the image you want
to capture. Note that the actual picture is about 15% larger either side of the actual
viewfinder image.
Press and hold the large button (indicated as the “Picture Taking Button” above). The
green ‘ON’ LED will then flash to indicate the picture taking process is active. Keep
the camera as still as possible until the green LED has stopped flashing. Once the
camera has taken a picture the 3 LEDs will flash in a sequence to let you know
whether the picture taken was of a good quality (Table 1) or poor quality (Table 2).
Once this occurs you can release the button unless you wish to create a voice
recording (see below for more details). Note that if you are not making a voice
recording it is possible to just press the picture taking button momentarily if preferred.
9