Installation Guide

8
2. Secure the Wedge Anchors to the Metal Fastener
Step 1. Place each 4" x 4" galvanized metal support post
fastener at the center of each pier. Mark the
base holes, then drill with a masonry drill bit to
the appropriate depth. Insert wedge anchors
into each hole and tap tight with a hammer.
Using a wrench, tighten the bolts to secure the
metal fastener to the pier.
Step 2. Stand up the 4" x 4" wood support post one at a
time in the post fastening bracket. Level the post
on two sides. Mark the bracket side hole
positions and then drill pilot holes. Secure the
post by screwing wood screws into the pilot
holes through the fastening bracket and into the
wood support post.
Note: Minimum post height from grade level is
8’6”.
Version 3.0, March 2010