Cast Stone Arbor Installation Instructions Single Beam Structure & Double Beam Structure 45-KITLO1L 45-KITLOOL 45-KITGO1S 45-KITGOOS 45-KITBO1S 45-KITBOOS 45-KITGO1F 45-KITGOOF 45-KITL01D 45-KITLOOD Revision A ELCARIM 10-09
Installation Instructions Cast Stone Arbor Installation Kit Contents: SINGLE BEAM ITEM DESCRIPTION Qty TYPE 1 Beam Plate 2 2 Post Plate 2 3 #12 x 1-1/2” Phillips Flat Head (Post Plate to Post) 4 Phillips Flat Head 4 #8 x 3/4” Flat Head Sheet Metal Screw (Beam Plate to Beam) 4 Flat Head Sheet Metal 5 #8 x 1-1/2” Flat Head Wood Screw (Stone Base to Post 12 req’d) (Extension Column to Post 8 req’d) 20 Phillips Flat Head 6 1/4-20 x 1/2” Phillips Pan Head (Beam Plate to Post Plate) 4 Phi
Installation Instructions Cast Stone Arbor Materials Required: 1. 2. 3. 4. 5. 6. 7. Two 4” x 4” wood support posts 10’ long (minimum) Exterior construction grade clear silicone sealant 80 lb. ready mix cement (est.
Installation Instructions Cast Stone Arbor IMPORTANT NOTES: Before digging, check for underground utilities. The North American One Call Referral Service at 1.888.258.0808 connects you to a national directory of utility companies. If installing onto an existing foundation, additional post brackets and hardware are required and not explained within the arbor installation instructions. Arbor Layout & Preparation: 1.
Installation Instructions Cast Stone Arbor Assembly Instructions for Single Beam Structure: *Some parts are heavy and will require two or more people to safely handle and install. 1. After the concrete has set, lower and center a cast stone column over each post and secure with (6) #8 x 1-1/2” long wood screws (Item #5) through the embedded metal bracket in the cast stone base and into each wooden post. Wood shims can be used to take up extra space between the bracket and post. 2.
Installation Instructions Cast Stone Arbor 8. Center the small mounting plate (Item #1) on the beam as shown. Mark the hole locations and pre-drill the holes for (Item #4). Apply adhesive (Item #7) between the plate and beam, then secure using (2) #8 x 3/4” long sheet metal screws (Item #4) (Figure 3). Figure 3 9. Place beam with attached bracket on top of column, align the mating holes and secure with (2) 1/4-20 pan head screws (Item #6) (Figure 4). Figure 4 10. See page 7 for attaching purlins.
Installation Instructions Cast Stone Arbor 7. Align the mounting holes of the post plate and the wing bracket. Center the two brackets over the extension column and secure in place with (2) #12 x 1 1/2” Phillips pan head (Item #3), screwing directly into the top of the wooden post (Figure 5). Apply a bead of silicone around the edge of the plate to provide a seal. Note: Figures 5 is shown with the post extended above the Column Extension for clarity only. Figure 5 8.