Installation Guide

ELCARIM 10-09
5
Installation Instructions
Cast Stone Arbor
Assembly Instructions for Single Beam Structure:
1. After the concrete has set, lower and center a cast stone column over each post and secure with
(6) #8 x 1-1/2” long wood screws (Item #5) through the embedded metal bracket in the cast
stone base and into each wooden post. Wood shims can be used to take up extra space
between the bracket and post.
2. Apply a bead of silicone around the top of the cast stone column.
3. Lower a base cap over each post and set in the silicone.
4. Accurately measure the length of the extension columns. Mark the finish height of the post from
the top of the cast stone cap. Be sure the marks on both posts are level. Carefully cut both posts
to length with a circular saw.
5. Slide and center an extension column over each post. Lightly mark or tape where the edge of
the column is located. Raise the column, apply silicone inside the taped area, and then lower the
column into the silicone.
6. Square the extension column, then secure the top of the extension column with (4) #8 x 1-1/2”
long wood screws (Item #5) through the embedded metal bracket in the extension column and
into each wooden post (Figure 1).
7. Align large post plate (Item #2) with the top of the column and attach with (2) #12 x 1-1/2” long
wood screws (Item #3) (Figure 2). The plate must be orientated so the support beam runs front
to back when mounted to the plate. Apply a bead of silicone around the edge of the plate to
provide a seal.
*Some parts are heavy and will require two or more people to safely handle and install.
Figure 1
Figure 2