User`s manual

10
2.1 Hard disk and CD-RW Installation
2.1.1 IDE Port
y Main substrate of this DVR has two IDE ports: they are indicated as Primary and Secondary.
y Up to two IDE devices (hard disk, CD-RW, and DVD-RW) are connected in parallel to the IDE ports, but the devices must
be designated as Mater or Slave.
y Please mount CD-RW (or DVD-RW) at the Secondary port, and designate it as a Slave.
y Refer to below table to mount a hard disk and CD-RW (or DVD-RW).
A Type
Storage Primary IDE Port Secondary IDE Port
HDD CD or DVD-RW Master Slave Master Slave
1 1
HDD ---- ---- CD-RW (DVD-RW)
4/8 Channel DVR
2 1
HDD HDD ---- CD-RW (DVD-RW)
B Type
Storage Primary IDE Port Secondary IDE Port
HDD CD or DVD-RW Master Slave Master Slave
1 1
HDD ---- ---- CD-RW (DVD-RW)
2 1
HDD HDD ---- CD-RW (DVD-RW)
3 1
HDD HDD HDD CD-RW (DVD-RW)
4/8/16 Channel
DVR
4 ----
HDD HDD HDD HDD
2.1.2 Master/Slave Designation
y Use Jumper pin to designate hard disk and CD-RW (or DVD-RW) as Master/Slave. Designation method is different by
products, so please check the designation method described on the cover. A connector for designation is located between
the 40-pin IDE connector and the 4-pin Power connector.
2.1.3 HDD Installation
y Securely fix a hard disk by using bracket and screws provided herewith.
y Please do not use any different hard disk cables (data cable and power supply cable) other than ones we provide.
Otherwise, it may cause damage to the hard disk.
2. Installation
CAUTION
Install hard disk after DVR power is off. Otherwise, it may cause permanent damage to the hard disk. To turn off DVR, please click ( )
SETUP>SYSTEM>Shutdown. Also, wait for 5 seconds before plugging in power supply again.
CAUTION
y For installation/addition/replacement/Removal of HDD (CD-RW, DVD-RW), make sure that DVR is turned off. Otherwise, it may
cause permanent damage to the HDD (CD-RW, DVD-RW).
y Installation/Addition/Moving/Replacement: You should start ‘HDD initialization’ including formatting. Otherwise, DVR won’t
recognize the hard disk and may begin to function abnormally. Please follow the below procedure for ‘HDD initialization’.
① (Date/Time setup) Set up the current date and time (SETUP>SYSTEM>Admin>Date/Time)
② (Initialization of system setup) All values in setup are restored to factory default settings
(SETUP>SYSTEM>Information>Status>Setup>Default).
③ (HDD format) HDD format is done by SETUP>SYSTEM>Admin>Storage>Format. If there are more than two HDDs, each must
be formatted, separately. When the format is completed, DVR will auto-reboot.
y Removal: Follow the Remove procedure even when a pre-installed hard disk has been removed. In
SETUP>SYSTEM>Admin>Storage>Format, click ( ) ‘Removed’ item under the discrete Format headings of a corresponding HDD
to discard ‘HDD’ item. When the Remove procedure is completed, DVR will auto-reboot.