User`s manual

2.1.4 CD-RW(or DVD-RW) Installation

y Securely fix CD-RW (or DVD-RW) by using bracket and screws provided herewith.

y Please do not use any different CD-RW (or DVD-RW) cables (data cable and power supply cable) other than the ones we

provide. Otherwise, it may cause damage to the CD-RW (or DVD-RW).

y Only one CD-RW (or DVD-RW) can be used. Mount it at the Secondary port, and designate it as a Slave.

2.2 Connector Wiring

2.2.1 Video-In/Out Connections

y Connect a camera to ‘VIDEO IN’.

y If you want to link camera input to another device, please connect the camera to ‘LOOP OUT’.

y Assure the ‘VIDEO IN’ and ‘LOOP OUT’ are connected properly, not oppositely.

2.2.2 Monitor Connections (Video Out, SVHS, VGA, SPOT)

y Use with CCTV monitor, SVHS monitor, and computer monitor. Please connect the CCTV monitor to ‘VIDEO OUT’, the

SVHS monitor to ‘SVHS’, the computer monitor to ‘VGA’, respectively. If necessary, you may connect another CCTV

monitor to ‘SPOT’.

2.2.3 Audio Connections

y Connect an audio device to ‘AUDIO IN’, and a speaker system to ‘AUDIO OUT’. Please use a speaker system with volume

adjustable.

2.2.4 TCP/IP(Ethernet) Connections

y Connect to ‘ETHERNET’ connector with the LAN cable.

y When connect to Internet, use an ordinary LAN cable (Non-cross cable). However, when connect directly to your PC,

please use only ‘Cross cable’.

2.2.5 Alarm Connections

y Connect Alarm Input (Sensor) to ‘AI 1~AI 4(AI 16)’ connectors, and connect Sensor Common to ‘G’ connector.

y Connect Alarm Output (buzzer, siren, etc.) to ‘AO 1~AO 4(AO 16)’ connectors, and connect Common to ‘G’ connector.

y Connect Pan/Tilt receiver (or Pan/Tilt camera) to ‘RS-485/422’ connector. Please observe proper (+) and (-) polarity.

2.2.6 RS-485/422 Connections

y PTZ Camera connector

y Please use TX+, TX-, RX+, and RX- terminals.

2.2.7 USB Connections

y There are three identical USB (2.0) ports in front and in rear. You may connect an external hard disk, an external USB

CD/DVD-RW, and a USB memory stick to the USB ports.

y When you use an external hard disk, please assure the connecting cable is not longer than 1.8m (6 ft).

2.2.8 RS-232 Connection

y This connector is for manufacturer only.

y Please do not use this connector.

2.2.9 Factory Reset Switch

y Reset the switch to restore all setup values of menus to factory default settings. You may also use this switch to initialize

System Log file.

y The switch is located in a pin hole on the left-hand side of the USB connector of the back panel.

y Put the clip pin into the switch hole on the monitor (Live) screen, and keep pressing until you feel the switch has clicked.

2.2.10 Power Supply Connections

y DC powered DVR: Plug the power supply adapter included in this product in ’DC12V’ connector. Input voltage is a free volt

CAUTION

PRESS FACTORY RESET SWITCH ONLY IN LIVE MODE. NEVER PRESS IN SETUP MODE.

CAUTION

Install CD-RW (or DVD-RW) hard disk after DVR power is off. Otherwise, it may cause permanent damage to the hard disk. To

turn off DVR, please click ( ) SETUP>SYSTEM>Shutdown. Also, wait for 5 seconds before plugging in power supply again.