Safety Manual

Charging Instructions & Safety Manual
MydCombi™ Base Unit
Page 8 of 9
Type of Modulation / Data Rate
-
GFSK / 1Mbit/s
Bluetooth FCC ID
-
2A2VJ-EyenoviaGen1
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Recommended separation distances between portable and mobile RF communications equipment and the
device, except for the distances indicated in the following table “Immunity to RF Wireless Communications
Equipment”.
The device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the device can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the device as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter (W)
Separation distance according to frequency of transmitter (m)
150 kHz to 80 MHz d = 1.2√P
80 MHz to 800 MHz d = 1.2√P
800 MHz to 2.7 GHz d =
2.3√P
0.01
0.12
0.12
0.23
0.1
0.38
0.38
0.73
1
1.2
1.2
2.3
10
3.8
3.8
7.3
100
12
12
23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in watts (W) according to the transmitter manufacturer. NOTE 1 At 80 MHz and 800
MHz, the separation distance for the higher frequency range applies. NOTE 2 These guidelines may not apply in all
situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
5. DISPOSAL:
6. REPORTING TO MANUFACTURER AND AUTHORITIES:
If a serious incident occurs in connection with this medical device affecting the operator or another person, the operator
(or person responsible) must report this serious incident to the manufacturer or seller of the medical device.
7. SYMBOLS USED IN LABELS ON THE MIDD BASE:
SYMBOL
DEFINITION
SYMBOL
DEFINITION
CAUTION, CONSULT ACCOMPANYING
DOCUMENTS
USE BY (YYYY-MM: YEAR-MONTH)
WARNING
Contains Lithium-Ion Battery
Lithium-Ion Batteries may pose environmental and safety hazards and should be disposed of in accordance with all
applicable Federal and State law.
WARNING
Electronic Equipment
Base Unit should be properly disposed of in accordance with all applicable State and Federal law.