User manual

ManualsBrandsEYEZONE ManualsBarcode ReaderP102-8

EYEZONE P102-3

User Manual

Oct 26, 07

34412F01

FCC Notices

It’s herewith confirmed to comply with the requirements of FCC Part 15 Rules. Operation is subject

to the following two conditions:

z This device may not cause harmful interference.

z This device must accept any interference received, including interference that may cause

undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a residential installation.

This equipment generated uses and can radiate radio frequency energy and if not installed and used

in accordance with the instruction manual may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio of television reception, which can be determined

by turning the equipment off or on, the user is encouraged to try to correct the interference by one or

more of the following measures:

z Reorient or relocate the receiving antenna.

z Increase the separation between the equipment and receiver.

z Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

z Consult the dealer or an experienced radio TV technician for help.

CE Declaration

This device complies with CE class B.

*EN55013

EN61000-3-2

EN61000-3-3

EN55020

Printed in Taiwan R.O.C.

All contents are subject to change without notice.

All trademarks are the property of their respective owner.

Summary of content (7 pages)

PAGE 1
FCC Notices EYEZONE P102-3 It’s herewith confirmed to comply with the requirements of FCC Part 15 Rules. Operation is subject to the following two conditions: User Manual z z This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
CONTENTS 1. Package Contents……………………..…………………….. 1 2. Introduction………………………………….……………... 1 3. Features…………………………………..………………… 2 4. Hardware Overview…………………………….…………... 2 5. Remote Control…………………………………………….. 3 6. Setting Up……………………………………..……..…….. 4 6.1 SLIDE SETUP……………………………………..…. 4 6.2 MUSIC SETUP…………….………………………… 4 6.3 MOVIE SETUP…………….………………………… 4 6.4 SLIDESHOW SETUP…………….……………………. 5 6.5 PREFERENCE……………….………………………… 5 7. Using the P102-3...………………………………………... 6 7.1 Play Picture File……………………………………..…. 6 7.
PAGE 3
. FEATURES 5. REMOTE CONTROL Supports multiple file formats: Picture, Music and Video. Supports CF, SD, MMC and MS (Pro) memory card. Built-in 10.2” TFT-LCD display and stereo speakers. Supports resolution up to 800 x 400. Includes a full-function infrared remote control. Motion Detector - The Eyezone P102-3 will play the demo file automatically after sensing approaching 1 2 3 4 5 subjects.
PAGE 4
6. SETTING UP 6.4 SLIDESHOW SETUP SLIDESHOW MODE：Set the slideshow to start automatically. FOLDER REPEAT：Set all files (picture, music or movie) in Press the “SETUP” button on the remote control to open the the folder to show only once or continuously (loop). “SETUP MENU – MAIN PAGE” shown in the following Use the “▲、▼、、 ▼ ▲ figure. There are five groups of sub-menu in the setup menu. INTERVAL TIME：Set the time each photo is shown to 1, 3, 5, 10, 30 or 60 seconds.
PAGE 5
7.2 PLAY MUSIC FILE 7. USING THE P102-3 Step 1: Press the “MUSIC” button on the remote control from any menu. Copy files (music, picture and movie) to the memory card first. 7.1 PLAY PICTURE FILE Step 1: Press the “SLIDE” button on the remote control from any menu. Step 2: The “MUSIC LIBRARY” will show all the music files on the memory card. Use the “▲、▼” buttons to select the music file, and press the “ENTER” button to play the music file.
PAGE 6
Step 1: Press the “MOVIE” button on the remote control from any menu. Step 1：Press the “FILE” button on the remote control from any menu. Step 2: The preview mode will show all the video files on the memory card. Step 2：You can see all the files (including picture, music and movie) on the left panel of the “FILE Use the “▲、▼、、 ▼ 7.4 FILE LIBRARY ▲ 7.3 PLAY MOVIE FILE LIBRARY”.
PAGE 7
9. TROUBLESHOOTING 8. MOTION DETECTION FUNCTION Make sure the PIR Sensor is connected correctly. Insert the memory card with demo files to the P102-3. NOTE：The first file in the list of File Library will be identified as default file. For Example： There are 6 demo files on the memory card. The file names are a01.xxx, 33.xxx, b55.xxx, 1abc.xxx, 07.xxx and A03.xxx (xxx is extension of the file). The file 07.xxx will be identified as default file.