Full Product Manual

GATEWAY
®
3G Solid Surface Portable Ramp Instructions Page 3 of 13
WARNINGS, CONT’D.
Before each use, remove ice, snow, dirt, leaves, and other debris on contact surfaces. Please refer to
‘MAINTENANCE AND SAFETY’ and ‘DEICING’ sections in the instruction manual for more information.
Do not lean on, walk on, or otherwise bear weight on the ramp until assembly is complete.
Do not run, jump, or play on or around the ramp.
Do not sit, stand, or climb on handrails.
Do not place anything on, under, or attach anything to the ramp including, but not limited to, planters,
lights, decorations, etc.
Improper use of the ramp could result in serious injury.
Always exercise caution when handling, assembling, and or using the ramp.
Aluminum conducts electricity. Do not use the ramp during electrical storms or in proximity to damaged
or exposed wiring.
Properly support and restrain the ramp in transit or storage.
For additional care, usage, or general safety information, please call 1-800-451-1903.
TOOLS AND HARDWARE TYPICALLY REQUIRED
✓ 1/2” SOCKET OR 1/2” WRENCH
✓ 1/4” MASONRY DRILL BIT (IF ANCHORING INTO CONCRETE)
✓ 1/4” NUT DRIVER OR SOCKET
✓ SEMI-PERMANENT ANCHORING HARDWARE & TOOLS (SEE ‘SETUP AND USE’ SECTION)
✓ POWER DRILL
✓ CONSTRUCTION ADHESIVE
✓ #2 PHILLIPS SCREWDRIVER
TABLE OF CONTENTS
SECTION 1: GETTING STARTED ............................................................................................................................... 4
SECTION 2: PACKAGE CONTENTS ........................................................................................................................ 4-5
SECTION 3: AVAILABLE RAMP LENGTHS AND STYLES ............................................................................................ 5
SECTION 4: INSTALLING HANDRAILS ................................................................................................................... 6-7
SECTION 5: INSTALLING HANDRAIL END LOOPS ................................................................................................. 8-9
SECTION 6: SETUP AND USE ................................................................................................................................. 10
SECTION 7: FINAL STEPS ....................................................................................................................................... 11
SECTION 8: MAINTENANCE AND SAFETY ............................................................................................................. 11
SECTION 9: DEICING ............................................................................................................................................. 11
SECTION 10: INCLINE CHART .................................................................................................................................. 12