Full Product Manual

GATEWAY
®
3G Solid Surface Portable Ramp Instructions Page 9 of 13
5.1.4. Place one O-ring over the swaged portion of the end loop, then push until it rests against
the loop shoulder (FIG. 9).
5.1.5. Repeat for all end loops.
FIG. 9
5.1.6. Using a 1/4” driver of choice, install one 1/4” self-drilling, self-tapping hex washer head
screw through the hole in the end loop attachment plate and into the handrail post (FIG. 10).
5.1.7. Repeat for all end loops, then tighten securely.
If the end loop being installed does not fit correctly, ensure you have the correct
loop for the location. Refer to FIGs. 7 and 8 for upper/lower end loop
identification.
5.1.8.
Install one #10 x 1/2” pan head Phillips self-drilling screw into each handrail (FIG. 10).
5.1.8.1.
To assist, use a punch to create a divot on the lower side of the ramp handrail
tube approximately 1” from the end of the handrail.
An alternate method is to pre-drill the hole with a 1/8” drill bit.
5.1.8.2.
Using a screwdriver, hand tighten the screw until no threads remain exposed.
FIG. 10