Instructions / Assembly

Page 71 of 74
7.8.4. Remove gravity latch and finger catch from bag.
IMPORTANT! Discard the screws included in the same bag as the gravity
latch and finger catch, as they will not be used. Instead, use the screws
included in the separate hardware bag for the following steps.
7.8.5. Center finger catch on the gate square tube opposite the hinge and mark center
of holes with a pencil. Drill three 1/8″ holes through one side of the vertical
handrail tube (FIG. 7.17).
7.8.6. Use 1/4" nut driver to secure catch with screws (FIG. 7.18).
FIG. 7.17 FIG. 7.18
7.8.7. Clip the latch to the finger catch and center on the step or ramp vertical square
tube. Mark center of the holes with pencil. Drill four 1/8″ holes through one side
of the vertical handrail tube (FIG. 7.19).
7.8.8. Use 1/4″ nut driver to secure latch using screws. (FIG. 7.20).
FIG. 7.19 FIG. 7.20
DRILL 5/16″ HOLES
WARNING
INSTALL BOLT FROM
THIS SIDE
#
8 X 1/2″ LONG HEX
WASHER HEAD SCREW
CENTER ON POST
#8 X 1/2″ LONG HEX
WASHER HEAD SCREW
DRILL 1/8″ HOLES