Instructions / Assembly

Page 48 of 74
FIG. 5.8
FIG. 5.9
5.4.10. Measure the gap between the long leg of the bracket and the post then cut the 1-
1/2” x 2” curb to the measured length, less 1/8” to account for the threaded inserts
which will be installed after cutting (FIG. 5.8).
5.4.11. Insert 5/16”-18 round threaded inserts into both ends of the curb. Use a rubber
mallet or similar tool to fully seat the threaded inserts as needed (FIG. 5.8).
5.4.12. Install 5/16″-18 x 1″ hex bolts through a 5/16” flat washers, the long leg of the
closure bracket, and the platform post into the 5/16”-18 round threaded inserts
installed in the curb. Use the hole which is 1/2” above the lowermost hole in the
platform post to align the curb correctly. (FIG. 5.9).
5.4.13. Confirm all fasteners are tightened securely. If you are installing a Single Line closure,
the installation is complete.