Instructions / Assembly

Page 63 of 74
7.4. LANDING PAD
7.4.1. The PLP (LANDING PAD) is used at the bottom of a ramp or ramp run to assist
mobility on soft ground. Contour the ground to remove any high or low areas which
would prevent portions of the Landing Pad from contacting the ground.
WARNING The Landing Pad is intended for use on the ground only. The
underside of the Landing Pad must be fully supported by the ground. It should
never be used in an elevated position like a ramp or a platform.
7.4.2. Slide the bottom plate into one of the three available slots (FIG. 7.5).
The ramp must be installed on the side marked for ramp attachment.
7.4.3. After installing the bottom plate, install #8-32 hex washer head thread cutting screws
into the screw slots on both sides (FIG. 7.6).
FIG. 7.5
FIG. 7.6