Instructions / Assembly

Page 23 of 74
3.4. INSTALL GROUND TRANSITION RAMP
3.4.1. The PRGT (RAMP GROUND TRANSITION) consists of two sections that need to be
installed into the ramp and connected together.
The PRGT (RAMP GROUND TRANSITION) is only designed to transition from the
lowest ramp in the run to the ground. Do NOT USE in any other location.
3.4.2. Lift the lowest end of the ramp/ramp run and bring the upper section PRGT into the
ramp end tread until the “hook” is engaged FIG. 3.10), then rotate into place (FIG.
3.11) and set back on the ground.
FIG. 3.10
FIG. 3.11
3.4.3. Slide the lower section ground transition ramp into upper section (FIG. 3.12).
3.4.4. Install #8-32 x 1/2” hex washer head thread cutting screws into the screw slots on
both sides where the sections connect (FIG. 3.13).
The hex washer head screws will keep the sections from sliding with respect to
each other but the sections can still be separated until they are installed in the
ramp and resting on the ground.
3.4.5. Holes and fasteners are included for anchoring into wood or concrete. Other
methods may be used when anchoring into other surfaces.
3.4.6. If connecting the lowest end of the ramp to a PLP (LANDING PAD) use a PRLT (RAMP
LOWER TRANSITION) instead of a RAMP GROUND TRANSITION. Please see ‘OPTIONAL
EQUIPMENT’ section for instructions.
FIG. 3.12
FIG. 3.13